If the disc drive is still stuck closed, insert the paper clip into the adjacent hole (to the right) and push again. If you’re successful, the disc tray will pop out slightly. Plug the power cord into the back of the console. Press the eject button to open and close the disc drive.
How do I fix my Xbox DVD drive?
Perform a hard power cycle by holding down the Xbox button on the console for 10 seconds. Once the console has completely shut down, press the Xbox button on the console again to restart it. Try your disc again. Wait a few seconds to see if the console recognizes it.
Can you replace the disk drive on Xbox?
Xbox One DG-6M1S Blu-ray DVD Drive Replacement The DVD drive will need to be “flashed” with your console’s security key or will need to have your original drive’s board swapped into the new replacement drive. Basic soldering required during installation. Professional installation is highly recommended.
Do all Xbox One S use the same disc drive?
Most consoles in the Xbox One gaming system have the able to play Blu-ray discs and DVDs; however, any discs played on the console must be from the same region as the console. Here’s what you need to know.
What happens when you replace a DVD drive on an Xbox 360?
If you already tried dumping the DVD key from the drive that came with the Xbox and flashing it to your replacement drive (using the correct firmware for the replacement drive as well) and the console still does not boot games (displays “Play DVD” when a game is inserted), you don’t have the correct DVD key and the console will never boot a game.
How do you replace the optical drive on an Xbox 360?
Use the tip of your spudger to release the clips on the bottom vent nearest the back of the Xbox. Remove the bottom vent from the 360. Insert the flat edge of a spudger between the faceplate and the outer casing near the power button. Run your spudger along the edge of the faceplate to release the clips securing it to the front of the console.
How can I change the firmware on my Xbox 360?
You can get information on disassembling the drives on many websites like llama. A firmware chip is attached to the ribbon cable on the circuit board of each drive. Remove these chips and swap them by taking the circuit board from the old drive and hooking it up to the new drive.
How can I get a new Xbox 360 drive?
Open up your Xbox 360 case and check all the technical specifications like manufacture date, type of drive, team, etc. Remove the old drive and disassemble both the old and new drives till you find the two circuit boards. You can get information on disassembling the drives on many websites like llama.
